You will need 1 low temp glue gun needle and thread 1- 2 inch square of felt 11- 2 1/2 inch satin squares 5- 2 inch satin squares 1 small pom pom wire headband or ribbon covered alligator clip
Carefully burn the edges of the satin. I didn't bother cutting out circles because the heat makes the satin curl up and when you gather it, it will look like you used circles...just without the hassle of having to cut them out!
Fold the petals in half, with the satin edge on the outside and stitch through the middle of the petal.
You will need to use three seperate threads for each set of 5 petals. This would look adorable with 6 or 7 and multiple layers of petals too.
When you have all the petals gathered it is time to carefully glue them around the felt. I love my low temp glue gun, it is all I use. Glue around the outer edge and adjust the petals as needed
Trim the thread.
Now you are ready to add the second layer. It is a smaller space so you will need to cinch up the thread a little more. Add the glue and work around the flower gently pulling on the thread to gather the petals.For the small inside layer I tie off the thread and adjust the petals and glue it all at one time.
Before I add the center, I pull apart the petals and fluff up the flower so it looks nice and full.
For the center in this flower I covered a soft pom pom with satin and wrapped wire around it to secure it.
I trimmed the excess satin off and sealed the edges. You could also cover a button with the satin. That would be so cute too!
Squeeze some glue in the center of the flower and add your embelishment. The great thing about the wool felt is if you glue something to it...it isn't moving. I love using wool felt for most of my creations. It also gives the flower a professional finished look.